What should I do if the current of the mill is unstable?

After analysis, it was found that the current instability of the pulverizer occurred in the production process, mainly because the material was not fed according to the demand, which led to failures. In general, there are the following points: the load caused by excessive feeding increases , The increase in temperature of the machine caused by the blockage of the air duct will lead to the occurrence of unstable current during production, so Xiaobian will analyze how to solve this problem for you.

1. The solution to the failure caused by too much feeding is to reduce the feeding amount and feed according to the needs of the mill equipment. The feeding amount should not be too much or too little, and the feeding speed should be reasonable and continuous and uniform. Feeding of raw materials is an effective means to ensure the smooth progress of production, and it is also conducive to the assurance of the quality of finished products.

2. The solution to the failure caused by the blockage of the air duct is to remove the accumulated powder in the air duct to ensure a clean air duct, and then blockage will cause the temperature of the machine to rise. Therefore, in response to this phenomenon, it is necessary to remove the residual air of the mill The pipe valve is opened wide, which can ensure smooth cooling and maintain the normal temperature of the mill, which can ensure a stable voltage.